This is a replica of the aluminum bracket that holds down the injector tubes on the "Super Hero" Pack from GB1 and GB2. This bracket was created to mimic the hand cut nature of the bracket that was used on the original pack. Included are (4) 3/16 inch aluminum rivets for parts up to 1/4 inch thick, as well as a separate plate that mounts on top of the bracket for additional strength.

Note: For best installation, mount your injector tubes first and then install the bracket, lining the holes up. On the original Pack, the holes did not line up in the direct center and some larger sized holes were drilled to ensure it still fit. You may need to modify your parts to get an accurate, but not perfect alignment.