#4980216
Thought I'd ask here before doing some deep digging.
I had the trap finished, with pedal all working with your code. I had to adjust the door settings slight so they open and close nicely without hitting each other.
Then gave a go at adding in new part to the code so that the states went like this, similar to 'gpstar' code as his wasn't working on my board for some reason even the V2.0.
Open, just bright light
Capture, flickering
Trap, baragraph and what not
Reset.
Either way it didn't work as intended and went to go back to your original code and noticed its not triggering anything, you start it and it beeps and the baragraph lights up but then when you press side knob or short the foster connector nothing.
Any ideas?
I noticed the servo's were hot but they still kinda work if adjusting the int setup in the code
I've unplugged everything individually to see for some reason if wire had done anything though it was stationary on my bench and everything got correct Live and Earth

Thanks
Jacque
    Proton Props UK

    Considering David orders most of the parts he do[…]

    Hasbro Ghostbusters

    While you're 100% correct about the function[…]

    Uniform Tips

    It does rain frequently here in London, but not to[…]

    The yellow parts are raw 3D prints, unsanded and u[…]