By Sir Jorgi
#4979398
I really hope this is not something someone has already asked but I am struggling with figuring out this kit. I followed the instructions from the site and have a brand new battery plugged in, is my bar graph supposed to be lit up? I try adjusting the dip switches as well as the potentiometer, I even flipped the ribbon cable around a couple times to make sure it was in fully. Am I missing something? Any help would be amazing, I am very new to all of this.
**UPDATED** I fixed it, I realized that I had put something in backward...every time. Again, new to this.

    The yellow parts are raw 3D prints, unsanded and u[…]

    Sorry, I hadn't seen any of these replies. Either […]

    Uniform Tips

    Sorry for the triple post (you guys have gotten […]

    Proton Props???

    Ugly Little Spud, Did you actually get the pack?[…]