- February 2nd, 2025, 7:18 pm#5003196
Began working on some leg hose connectors. Used pics of the screen-used as a reference, and assembled them in Microsoft 3D Builder. Left is GB1/2, right is FE Engineer.
The hole in the GB1/2 connector is measured to fit 1/2" OD tubing, which I'll include (dyed or clear) with the connector once I print some out for my Etsy store.
How do they look? I have very little experience with 3D design, but I gave it a shot.
The hole in the GB1/2 connector is measured to fit 1/2" OD tubing, which I'll include (dyed or clear) with the connector once I print some out for my Etsy store.
How do they look? I have very little experience with 3D design, but I gave it a shot.
mike_waclo liked this
- By Far451
- By mrmichaelt
- By GBFans
- By edspengler