General Consensus for Afterlife P Clamp size?

General Consensus for Afterlife P Clamp size?#4978413

By Ecto_1X - February 5th, 2023, 11:32 am

- February 5th, 2023, 11:32 am#4978413

I've heard 1.5", 1/4" and 1.25".. which one of these is the most accurate?

My Uniform Build

Re: General Consensus for Afterlife P Clamp size?#4978436

By TobinsGuide - February 5th, 2023, 5:16 pm

- February 5th, 2023, 5:16 pm#4978436

This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

I used a 1 3/8 inch.

AKIHISA 12 Pack 1-3/8in Stainless steel-304 Cable Clamps,Pipe Fittings & Accessories,Rubber Cushioned Insulated Clamps,Pipe Clamp,Metal Clamp,Wire Cor https://www.amazon.com/dp/B08CSRZVYH/re ... FTppniYiQc

Seems to fit well. Somewhere between the 1.25" and 1.5" I'd heard different people argue in favor of. It's a good fit.

Re: General Consensus for Afterlife P Clamp size?#4978444

By lonerthx - February 5th, 2023, 11:04 pm

- February 5th, 2023, 11:04 pm#4978444

Zooming in and slightly enhancing one of the photos taken by Adam Savage, I believe I can clearly see 25" stamped on the clamp , it's hard to make out what is written before it though, so it could be 1/2 5" but that makes less sense than say 1.25"