I had to take some time off, but I'm back working on the RTV.
Here are the latest pictures. I see the shocks are now too far from the body (facepalm) so I'll have to fix that.
as an FYI, other than the Traxxas donor car, the rear red light cover, the aluminum handle, flashlight innards, and the rear connector, everything was(or can be) 3d printed.
I did use aluminum and a real Cal-r resistor, but 3d printed versions are pretty good as well.
The door opening mechanism has changed 3 times since I last posted. I now use servos at the rear end only, the front door pushrods are for show only. (it works well and takes up a lot less space!)
Next is figuring out where to put the innards. The laser smoke show is coming along, but I need to figure out balancing the mirror on the fan since it rattles up a storm. My new SLA printer did a nice job of the fan blades.
I will post pictures of the inside when I get there.