- May 7th, 2021, 11:21 am#4949037
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.
So, I got the Ninjatunes electronics package for the proton pack, which includes a connector that fires off when you overheat the pack to trigger a smoke kit in the N-filter. Hooking up to that is trivial. What I want to do is that, but I also want to use a remote trigger to fire off smoke on demand (using something like https://amzn.to/3bdmQQ2). I'm just hoping someone can check me on my wiring plans here. Here's the schematic:
D3 exists to cut the fan out of the circuit when using the remote control. (So, imagine when it overheats, it smokes and actively vents through the N Filter. When you use the remote, it just casually leaks smoke out.)
I assume I probably need a buck converter or linear voltage regulator on the vape coil to cut it down to like 4-5V too, yeah?
So, I got the Ninjatunes electronics package for the proton pack, which includes a connector that fires off when you overheat the pack to trigger a smoke kit in the N-filter. Hooking up to that is trivial. What I want to do is that, but I also want to use a remote trigger to fire off smoke on demand (using something like https://amzn.to/3bdmQQ2). I'm just hoping someone can check me on my wiring plans here. Here's the schematic:
D3 exists to cut the fan out of the circuit when using the remote control. (So, imagine when it overheats, it smokes and actively vents through the N Filter. When you use the remote, it just casually leaks smoke out.)
I assume I probably need a buck converter or linear voltage regulator on the vape coil to cut it down to like 4-5V too, yeah?