User avatar
By Poppa_Merritt
#4998710
I am working on a minor mod and cant seem to figure out how to remove the inside section of the Booster Tube so that I can add a Slime Canister like the TVG Pack. Can anyone point a guy in the right direction or explain how to get that out of there ?
By MeChANiClySM
#4998782
I just worked my way through this, but here's what I did:

1) Disconnect the Ion Arm switch.
2) Remove the 4 screws holding the Ion Arm in place.
3) Remove the Ion Arm (it requires some prying).
4) Unscrew the 2 screws at the very bottom of the Booster Tube on the inside.
5) Remove the screw about halfway up the tube on the inside...it's roughly in line with the top of the Power Cell (mine was covered by a velcro strip for a battery pack so I cut a small hole in the velcro to get at it.
6) The booster tube should slide out.

It might be possible to remove the Booster without taking the Ion Arm out, but I wasn't sure how and if it was connected to the tube, so I went and took it out first just to get it out of the way.

Hope that helps!
By DoRayBillgon
#5000273
MeChANiClySM wrote: June 21st, 2024, 8:42 am I just worked my way through this, but here's what I did:

1) Disconnect the Ion Arm switch.
2) Remove the 4 screws holding the Ion Arm in place.
3) Remove the Ion Arm (it requires some prying).
4) Unscrew the 2 screws at the very bottom of the Booster Tube on the inside.
5) Remove the screw about halfway up the tube on the inside...it's roughly in line with the top of the Power Cell (mine was covered by a velcro strip for a battery pack so I cut a small hole in the velcro to get at it.
6) The booster tube should slide out.

It might be possible to remove the Booster without taking the Ion Arm out, but I wasn't sure how and if it was connected to the tube, so I went and took it out first just to get it out of the way.

Hope that helps!
hey there... im about to remove my booster tube. when you reassembled, did it give any insight to whether or not you needed to remove the ion arm?

    Good Morning fellow ghostheads! I just wanted to […]

    Once we get a real look at the EMF mode I'm hoping[…]

    Nobody in the ghostbusting community cares (or at […]

    I’ve read they’ve changed the offer to[…]