I was hoping someone who managed to snag one of the metal heatsinks from Propforge would be able to give me the measurements…never mind
Thanks for answering on the FB page too, thought I’d give my question a chance on here too.
Sorry, I just saw your reply!
Thanks for getting back to me and offering the measurements!
I’m kind of looking for all measurements if it’s not too much of an ask. No worries if you can’t, there’s absolutely no pressure at all.
Any help at all is much appreciated!
Hasbro wand just came in. Printed some new grips […]
Here is the proton pack that I recently built for […]
I was trying to send a message a month but after 2[…]
There a couple new ones like photos of the under[…]