- October 6th, 2021, 11:19 pm#4956739
Hey Guys,
This problem started for me about 2 years ago, hasnt gotten worse, but hasnt gotten better. Im curious if any one else has run into this.....When first starting the Matty wand, it takes about 3 full firing sequences to start t rumble/vibrate. I now also have to manually pull the light cylinder away from the base instead of moving the lever up and down. If I use it enough over a few hours the lever starts to function again, but its not like it was when I got it. Any suggestions? My Pack setup runs with the matty and would hate to lose it someday.
This problem started for me about 2 years ago, hasnt gotten worse, but hasnt gotten better. Im curious if any one else has run into this.....When first starting the Matty wand, it takes about 3 full firing sequences to start t rumble/vibrate. I now also have to manually pull the light cylinder away from the base instead of moving the lever up and down. If I use it enough over a few hours the lever starts to function again, but its not like it was when I got it. Any suggestions? My Pack setup runs with the matty and would hate to lose it someday.
ccv66 liked this