- September 3rd, 2021, 2:26 pm#4955102
This has been work in progress since spring of last year, I took my time with it since the point of making it was to wear to the new movie. It's a studio creations vacuum formed shell that I reinforced with fiberglass, the motherboard is a GBfans (you can see a small lip on the left size of the pack since the studio creations shell wasn't 100% accurate but we wanted to work with a small budget), I installed a GBfans cyclotron light kit, and most of the other parts were 3D printed here at home aside from the bumper. The wires and vinyl stickers I bought over on Etsy. Ribbon cable was bought from Fincher Technologies. It's not quite there yet, I was working off of "leaked" photos that kept getting taken down and other fanmade renditions.
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.
Check out my ghost hunting documentary!!
A Haunting in Hinsdalenow on Amazon!
And now FREE on Tubi!!!
Check out my ghost hunting documentary!!
A Haunting in Hinsdalenow on Amazon!
And now FREE on Tubi!!!