- January 18th, 2022, 8:03 am#4965565![Image](https://www.wiltronics.com.au/wp-content/uploads/images/components/momentary-pushbutton-switch-dpdt.jpg)
c.fago wrote: ↑January 16th, 2022, 4:56 pm If you mean wired to the gbfans wand light kit via the Auxiliary connection, I haven't tried it yet but I'm pretty sure it would be less bright. I already wired a similar 12V led lamp via the Wand Tip connection to replace the wand tip expansion kit or the original 10mm RGB led. Since these connections only supply 3 volts, a 3 to 12V voltage booster is required, but even so the output power is not enough to get the full brightness of the lamp. A way should be found to run it directly at 12V. By eye I would say that through the Aux connection/voltage booster it can reach just a little more than half of its full brightness.Yep and one way to run it at 12V would be to use a DPDT switch, that way you can control both the wand board and the 12V led at the same time, but separately.
![Image](https://www.wiltronics.com.au/wp-content/uploads/images/components/momentary-pushbutton-switch-dpdt.jpg)